Murexin DBS-50 Self Adhesive Sealing Tape 25m Roll

Murexin Self-Adhesive Sealing Tape DPS-50

Self-adhesive sealing tape made from butyl coated polypropylene fleece, with divided, overlapping silicone paper covering. Coated with highly elastic, self-adhesive butyl rubber. System component for sealing in wall and floor areas. For bridging and sealing connecting and corner joints.

• Self-adhesive
• Water-impermeable
• With fleece side

Storage
Can be stored frost-free, cool, and dry on wooden shelves in the unopened original container.

Processing
Stick down sealing tape and press it down firmly. Then completely rework all the outer zones and
the edges with the seal.

Tile laying technology
Mastic asphalt, Plaster, Lime-cement plaster, Masonry, Gypsum plasterboards, Smooth concrete, Aerated concrete, Wooden substrates, Metal, Synthetic materials (trial bonding recommended).
The substrate must be dry, frost-free, solid, weight-bearing, dimensionally stable, free of dust, dirt,
oil, grease, release agents and loose parts, and it must comply with the applicable technical
national and European directives, standards and "generally accepted rules of the trade".

Technical data
Temperature resistance -35°C bis +80°C
Thickness 0.8 0,8 mm
Butyl weight 585 g/m²
Water impermeability approx. 0.2 bar

Material information:

• When working outside the ideal temperature and/or humidity range, the material properties may change significantly.
• Temper materials accordingly before processing!
• To retain the product properties, no foreign materials may be mixed in!
• Water dosing amounts or thinning specifications must be precisely kept!
• Check coloured products before use for colour accuracy!
• Colour consistency can only be guaranteed within a batch.
• The colouring is significantly influenced by the environmental conditions.

Environmental advice:

• Do not process at temperatures below +5 °C!
• The ideal temperature range for material, substrate and air is +15 °C to +25 °C.
• The ideal air relative humidity range is between 40% to 60%.
• Increased humidity and/or lower temperatures delay, lower air humidity and/or higher temperatures accelerate drying, setting and hardening.
• Ensure sufficient ventilation during the drying, reaction and hardening phase; avoid draughts!
• Protect from direct sublight, wind and weather!
• Protect adjacent components!